HERO DWARF WAVE 1 FUBAS

I printed it at 9 cm as a test. The supports are very delicate, but with extreme care and tweezers, they can be removed without leaving damage, but they must be removed one by one slowly, like when you caress a girl/boy
PLA Basic white
0.16 extra fine
hybrid tree
10mm outer brim only
object spacing 0mm

If you want to collect them all… come here (the trap is ready)

https://makerworld.com/en/@Gara/upload

Technical notes (the truth, not poetry)

I prefer to print them in a single color and paint them after priming, using acrylic markers.
The colored images serve as coloring examples, but then it's very much a matter of personal taste.
This design originated from an AI generation (Tripo) that I manually refined and tested on FDM prints to ensure printability and quality.
The “real” photos are the single-color ones (white).
When removing supports: tweezers, calm, delicacy (no need to go Rambo on the support, or you'll cry).

As always (the part that decides whether you print or curse)

There's only one key: bed adhesion.
I use CryoGrip Pro Frostbite, and the adhesion is so good that prints seem to have a mortgage on the bed: they never let go.
I mainly use Bambu filaments and have no problems.
If you have a different setup:

focus on adhesion (first and foremost)

use dry and quality filament

do things cleanly and you'll see that “mysteriously” everything works much better