Search models, users, collections, and posts
Toyota Hilux 2025 - 3D Print Model (2 Profiles)
IP Report
Print Profile(2)
Print profile without the section cut.
Designer
12.3 h
1 plate
Print profile with the section cut in the middle
Designer
12.1 h
1 plate
Open in Bambu Studio
Boost
182
390
16
5
351
87
Released
Description
I present my new model - Toyota Hilux 2025. 🚙
You can choose between two print profiles, depending on what matters more to you: simplicity or clean surface finish.
Print Profile 1 - One-piece body
- Single-piece model (no gluing)
- Needs more supports
- Support removal may leave scars on the rear/underside
Print Profile 2 - Split body (cleaner finish)
- Body is split into two parts
- Requires super glue for assembly
- Minimal support scarring compared to Profile 1
Recommended print settings
- Supports: enabled (both profiles)
- Walls: 3
- Infill: ~15% (your choice)
Want functional wheels?
If you want a functional wheel version, leave a Like and comment “WHEELS”.
At 100 likes, I’ll upload an additional print profile with spinning wheels. 🔧
Boost Me (for free)
Free for you, but helps me more than you could imagine! <3
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (16)