Novation Launchpad X Stand

This is a remix of @micheleianni86’s Launchpad Mini stand. Shoutout to them for the original design and for allowing remixes. I rescaled and adjusted the proportions so it fits the Launchpad X snugly.

The model is split in half with dovetails so it fits on the A1 Mini build plate.

Printing Notes:

• Requires supports. Standard supports were used (default style, 50% overhang threshold, small overhang removal enabled). These settings are included in the provided .m3f file.
• Printed and tested in PLA Silk. Standard PLA or matte PLA should also work, but may result in a slightly tighter dovetail fit.
• Best results were achieved using the 0.16 mm “Optimal” profile, which produced the most consistent and snug dovetail fit.

Installation Notes:

• The dovetails are a very tight fit. For best results, place the shorter piece flat on a table and firmly press the larger piece into the dovetail by hand as far as it will go.
• Once started, use a rubber mallet or another soft, weighted tool to tap it fully flush with controlled, even force.

Designed for a precise, interference-fit assembly with no adhesives required. Once assembled, the fit is intended to be semi-permanent.