Smell-Proof Joint Case (With Lighter!)

DISCLAIMER

DO NOT STORE ANY HOT/BURNING/LIT MATERIALS INSIDE THIS CONTAINER. THE MATERIAL CANNOT WITHSTAND IT AND WILL CAUSE PLASTIC TO MELT INTO YOUR MATERIAL AND BE EXTREMELY UNSAFE TO INHALE OR CONSUME.

I am not responsible or liable for how you choose to use this product, please understand how material and heat interactions occur and can affect your health. Enjoy!

Check out all my smoking accessories and Puffco device accessories here!

Smoking Collection

Puffco Collection

Update 2/24/26:

Removed brim from print profiles

Update 2/7/26:

Edited to make all joint holes the same depth of 70mm, can also fit BIC and Clipper lighters now!

I also linked the wrong O-rings, it needs 35mm o-rings!!!

Also changed all print profiles to PETG

I will also add a separate print profile here for King sized joints! - Check print profiles on this page!

I will also make a separate post for a doob tube that holds ONLY joints here! LINK

I'm currently thinking about how I can make it safe to store hot material inside container. Will update when I find a solution!

_______________________________________________________________________________________

Here is my smell-proof doob tube/joint box/cigarette box!

With the capacity to conceal one standard Bic lighter, two small doobs, and one large doob, this baby will have you blending in in no time!

The two print profiles for 1 ¼ and King size papers are sized at 70mm and 100mm respectively. This is just the distance from the bottom to the top of each cylinder, so longer J's can be stored but too long and they may interfere with the lid closing. 

To assemble, you will need three (3) M3x35mm socket head machine screws (I used these from Amazon, which have a head with a 5.4mm diameter and 3mm depth) and one (1) 35mm OD x 2.5mm width O-ring (I used these from Amazon) The screw head clearance is a 6mm diameter

I also included two plates that use a Beam Interlocked TPU 85A/90A O-ring if you have an H2D or H2C! I think the O-ring works better and is more cost efficient, but if you'd like to try it out and don't feel like buying O-rings it still works great!

When screwing in the top latch screw, do not over-tighten, or the lid will bow and interfere with the box closing.

I would recommend printing each of the three pieces one at a time to avoid layer lines on the taller pieces. 

I printed in PLA but PETG would work well too. I sliced it with pretty dense settings (5 walls, gyroid, 25% infill) to maximize smell-proofing. Feel free to increase these to your heart's content.

If there are any requests to make further changes such as being able to hold longer J's please let me know in the comments and I will definitely make further iterations!