Sleeping Bezel Dragon Monitor

Add a touch of fantasy to your workspace with this adorable sleeping dragon!

This model is specifically designed to rest on the top edge of your computer monitor, keeping watch over your tasks while it naps.

Design Details:

• Side Profile Only: Please note that this is not a full 3D dragon. It represents the right lateral section of the creature.
• Flush Cut for Mounting: The left side of the model is cut completely flat. This flat surface is designed to sit flush against the monitor screen and bezel, creating the illusion that the dragon is lying securely on the edge with its legs and head dangling over the front.

Printing Instructions & Supports:

To capture the high detail of the scales and the complex geometry of the folded wings, this model does present some printing challenges:

• Requires Abundant Supports: Due to the many overhangs (specifically under the chin, front claws, and wings), the use of supports is mandatory for a successful print. Do not attempt to print without them.
• Optimized for Easy Removal: While the model requires a significant amount of support material, the profile has been optimized to ensure the interface between the support and the print is as clean as possible. With standard slicer settings, the support removal process is designed to be easier, allowing the structures to snap off cleanly with minimal scarring on the final figure.

Enjoy your new desk companion!

----------------------------------------------------------------------- OTHER MODELS IN MY PROFILE :) -------------------------------------------------------------------------------------------------------