Search models, users, collections, and posts
support dryer sunlu p1/x1c/p2s
IP Report
Print Profile(1)
0.12mm layer, 2 walls, 15% infill
Designer
17.3 h
3 plates
Open in Bambu Studio
Boost
4
8
0
0
5
0
Released
Description
Content has been automatically translated.
Support for the Sunlu/Jayo S1 filament dryer, an old but still efficient model.
Allows raising the dryer approximately 32 cm from the ground, near the filament inlet.
Two options are offered:
Option A: the small support (131mm long)
Option B: The large support if the bin does not fit the option or, if space is sufficient (169mm long)
Two pillar options are offered:
Option A: a single pillar, requires less filament (90g)
Option B: two pillars, stronger but requires more filament (125g)
required screws: two M3 screws required to connect the support to the 3D printer
Pillar screws: Works very well without
Dryer base screws: M3x30 screw recommended
prints very well without support
For my part, I printed it in ABS
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (0)