License Plate Holder Austria - minimalist!

short version in english: This is a small & minimal model that allows you to install austrian license plates with 120mm height, just clip them into the mount and you're done! Print orientation and hard supports are necessary for optimal print result!

You may / you should use a about 1-2mm of rubber between your car and the license plate brackets as shown in the photos for easier plate installation and less probablity to scratch your paint/your car wit the mount! I only tested it for austrian license plates but it should also suit the following states in europa: Denmark, Finland

after printing, remove all supports the same way and maybe clean the print edges with a file and a little bit of heat

thank you for your support and your consideration

feel free to like, share and/or boost me

This license plate holder fits Austrian single-line license plates with 120mm height or also for other countries that use 120mm high license plates, such as Denmark or Finland. The print direction and the marked supports are important for print bed adhesion, please do not remove them. In this print direction, these minimalist clip attachments hold very well, even years later without problems!

On the back, it is advisable to attach a self-adhesive rubber of approx. 1-2mm height to 1. create a distance to the paint/vehicle to avoid scratching anything and 2. make it easier to clip the license plate in and out. Information on this can be found in the pictures!

After printing, remove all supports and process the edges with a file and finish with a little heat.

If you have any questions, feel free to contact me!

Feel free to like, share or boost :)