Fixed-wing Titan Comet

Dual engine power, 1.46m wingspan, extremely large internal fuselage area, two partitions, very easy to control.

2312 DJI disassembled motors bought for 9.9 on Xianyu. 9450 counter-rotating propellers are 5.5 per pair. The complete set of carbon rods costs 13 yuan,

With an ultra-low budget, I, a pauper, absolutely love it. It's a must-have model for beginners.

It can take off by hand launch with a flight controller or by rolling take-off with wheels.

The ultimate FPV and mapping experience built for dual-pull drones. The Comet is ultra-efficient, flying up to 4.5
Incredible attention to detail has gone into making the Comet lightweight yet structurally rigid. The Comet is equipped with a dual-layer FPV deck suitable for action camera gimbals, or pan/tilt setups.

It has enough space in the fuselage to fit your entire arm through the rear hatch or front cowl. Additionally, there are optional fuselage sections that allow for the installation of a mapping camera in the belly. The wings are also detachable for transport.

Like a falcon, there is ample space under the wings for installing VTX/RX or other video transmission equipment.

8MM diameter carbon rods, 500MM length, 4 pieces

4MM diameter carbon rods, 400MM length, 2 pieces

3MM diameter carbon rods, 500MM length one piece, 200MM length two pieces, 60MM length one piece

Optimized slicing, upgraded to new slicing software with 2% 2D lattice infill, specifically designed for model aircraft wings.

The screw positions have been given a modifier,

Very suitable for beginners to print directly, no modifications needed. If there are experts with better print profiles, please advise!

If you have any questions, feel free to leave comments for discussion. Wish everyone happy flying and no crashes!!

Bluebird 45A ESCs, 2 pieces