Universal Speargun Tip Protector & Wall Hanger

Protect your gear and organize your space. This cap protects your sharp speargun tip from getting dull and prevents accidental punctures in your car seats, wetsuit, or gear bag.

• Universal Fit: It has special internal ribs that flex. It fits tight on 6mm shafts and expands for 7mm shafts. One cap for all your guns.
• Wall Hanger: The top loop is reinforced. You can tie a cord to it and use the cap to hang your whole speargun on the wall for storage.
• Drainage: It lets water out so your tip won't rust.

Print Settings (Easy Mode)

• Supports: NO. (It prints perfectly without them).
• Material: PETG is recommended. PLA works good as well.
• Walls: 4 or 5 walls (To make it super strong).
• Brim: Recommended (Add a 5mm brim so it doesn't fall over while printing).
• How to use Tie a piece of Dyneema or strong cord through the hole. Push it onto the spear tip. Now you can hang your gun safely!