Natsu Dragnir - Fairytail

CAREFUL: Use of any PLA grade other than the specified material may change the calibrated transmission distance values and consequently alter the resulting output.

ATTENTION: L'utilisation d'un grade de PLA autre que le matériau spécifié peut modifier les valeurs de distance de transmission calibrées et ainsi altérer le résultat obtenu.

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 240x208.24mm in size

You may print at higher layer heights below the Base Thickness of 0.48mm
The Max allowed Thickness is 3.52mm and the Actual Thickness is 3.44mm

    #000000 PLA BambuLab Basic Black  Transmission Distance: 0.6
    #00358e PLA BambuLab Basic Blue  Transmission Distance: 4
    #de4343 PLA BambuLab Matte Scarlet Red  Transmission Distance: 2
    #ff5869 PLA BambuLab Basic Pink  Transmission Distance: 8
    #9b9ea0 PLA BambuLab Matte Ash Gray  Transmission Distance: 1.5
    #ff6a13 PLA Bambulab Basic orange  Transmission Distance: 4.4
    #fce300 PLA BambuLab Basic Yellow  Transmission Distance: 6
    #e8dbb7 PLA BambuLab Matte Desert Tan  Transmission Distance: 1
    #ffffff PLA BambuLab Matte Ivory White  Transmission Distance: 3.5
This print uses 9 unique filaments

Swap Instructions:
    Start with Black
    At layer #17 (1.44mm) swap to Blue
    At layer #20 (1.68mm) swap to Scarlet Red
    At layer #25 (2.08mm) swap to Pink
    At layer #28 (2.32mm) swap to Ash Gray
    At layer #30 (2.48mm) swap to orange
    At layer #32 (2.64mm) swap to Yellow
    At layer #36 (2.96mm) swap to Desert Tan
    At layer #38 (3.12mm) swap to Ivory White for the rest.