Amazon Echo Auto Hanger

Purpose

I purchased an Amazon Echo Auto and did not want to adhere it to the dash inside my vehicle. This allows for the Echo Auto to connect to the provided USB Cigarette lighter and is supported by the opening from the plug below.

Printing Recommendations

I have only attempted to print this with Sunlu High Speed PETG filament. I believe the clearances will allow for printing in other brand's PLA without issue but I cannot guarantee this.

• Supports: Print with auto-generated tree supports in Bambu Studio. The .3mf print profile includes them.
• Infill: 15% infill

Assembly Instructions

1. Remove supports carefully.
2. Clean indention of the hanger with rubbing alcohol and allow it to dry.
3. Remove adhesive backing from the Echo Auto mic/speaker.
4. Align with the indention of the hanger.
   1. It can be helpful to align with one side and then roll the mic/speaker until it is in place.
5. Press and hold firmly for 30 seconds to ensure adhesion.

** I live in Texas and have not had the ability to test if the provided adhesive will hold in a hot car in the middle of summer with the Texas heat. Please keep this in mind.