HEROME STRANGER THINGS EDDIE MUNSON

For testing, I printed it 10 cm. The supports are very delicate, but with extreme care and tweezers, they can be removed without leaving damage. They must be removed one by one slowly, like when you caress a girl/boy
PLA Basic White
0.16 extra fine
hybrid tree supports
10mm outer brim only
0mm object spacing

If you want to collect them all… come here (the trap is already set)

https://makerworld.com/en/@Gara/upload

Technical notes (the truth, not the poetry)

I prefer to print them in a single color and paint them after priming, using acrylic markers
The colored images serve as coloring examples, but then it comes down to personal taste
This design originated from an AI generation (Tripo) which I manually refined and tested on FDM prints to ensure printability and quality
The “real” photos are the single-color ones (white)
When removing the supports: tweezers, calm, delicacy (no need to go Rambo on the support, or you'll cry)

As always (the part that decides whether you print or swear)

There is only one key: bed adhesion
I use CryoGrip Pro Frostbite and the adhesion is so good that the prints seem to have a mortgage on the bed: they never let go
I mainly use Bambu filaments and have no problems
If you have a different setup:

focus on adhesion (first and foremost)

use dry, quality filament

do things cleanly and you'll see that “mysteriously” everything works much better