Search models, users, collections, and posts
Piaggio Vespa Ciao Headlight Grille
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 50% infill
Designer
1.5 h
1 plate
Open in Bambu Studio
Boost
14
34
2
0
57
33
Released
Description
Undo both M3 screws that hold the headlight in place and replace and mount the grille with slightly longer M3 bolts than the original. Fit is not 100% but because of the lamp heat the grille will deform into place after a short ride.
Print in PETG to avoid too severe deformation.
License
This user content is licensed under a Standard Digital File License.
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (2)