Search models, users, collections, and posts
Zuca MaxDisctance 16ft holder
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.1 h
1 plate
Open in Bambu Studio
Boost
7
34
5
0
27
22
Released
Description
I needed a mount for my MaxDisctance retriever on my Zuca Compact, but I didn't want to use the zip tie ones. Also, I wanted the brackets to have a more positive hold on the retriever. With this, just set the bottom into the bottom holder and snap the retriever into the top through the opening.
Requires 3x M6x35mm socket head screws to install as the original flat head screws are not long enough to go through the new brackets.
Clip diameter is 31mm, Cottom diameter is 37mm
I printed in PETG for a bit more flexibility and more resistance to heat deformation in my car.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (5)