P2S TPU Holder

Decided to try this because it was a quick print. Connecting the rod was hard and makes it feel somewhat like a permanent fix. Had issues with filament wrapping around the rod.

Just printed and it is great. I’m running a test print using it right now. Also, any suggestions for my setup? I’m tight on space though.

Apart from a small printing error, which is probably due to the filament, a great print

working great! no issues!

am I using this wrong? glued one side but it regularly shakes apart falling into the printer

Looks very good and fits optimally. Now it works with the TPU print too

Beautiful and easy print. Some chamfers would further enhance the print and it would be easy

This allows the TPU filament to be loaded without any problems and the holder fits the P2S perfectly. Thanks for that

works very well, I had a small spool of tpu to try out, bit finicky to get it to not unspool on itself but definitely worked in a pinch

great except for the stick and the whole thing needs to be taller but overall its good