Modular Filament Storage System 25x25cm customizable
Print Profile(4)
Description
I was looking for a symmetrical storage system that can accommodate both refill and full-sized rolls, even with vacuum bags
I have now designed one myself that is printable with both the H2 series and smaller models
Assembly is simple
- Print parts
- Place the rails into the frames and secure them with 2 screws per frame, paying attention to the arrow on the bottom. It should always point forward
- Remove the rail guide for easier assembly
- Attach the aluminum rod holders to the rails with 3 screws per holder
- Slide the aluminum rod into the holders
- Slide the front piece onto the aluminum rods
- Slide the back piece onto the aluminum rods
- Reassemble the rail guide with the rails
- If multiple modules are present, connect them with 2 screws per frame
And DONE
The following materials were used for one module
20mm aluminum tubes are used as rods, cut to the length of the selected rail length
Rails can be selected between 250 - 700mm depending on requirements
Link: https://ebay.us/m/30HLVC
In my model, 450mm rails were used
Screws
20x countersunk screws 4x10mm
For connecting multiple modules
countersunk screws 3x14mm
are needed
License
You may create derivative works based on this object, provided that all such derivative works are published exclusively on the MakerWorld platform and include proper attribution to the original creator. You may not share, upload, host, distribute, or publish this object—or any derivative work of this object—on any other digital platform, marketplace, or distribution channel. Commercial use of this object and any derivative works is strictly prohibited. This includes, but is not limited to, selling, renting, sublicensing, or using the object in any context in which you receive monetary compensation or other financial benefits.
Comment & Rating (58)