Glock 17/19 w/ Streamlight TLR-1 OWB Holster

  Here by popular demand, the Glock 17 Streamlight TLR-1 OWB holster.  Same as all of my other OWB designs, this is set up for Safariland bolt pattern, using #8-31 hardware and compatible with my Parametric Holster Hanger design and my Belt Mount design.  This will also work with the Braun light, Ruger RXMs and most Glock clones.  I have included a Right and Left hand design, as long as a low-cut option for Competition.  This isn't designed specifically for the G19, so if you run one, you'll notice that it doesn't reach the end of the holster, but I didn't want to cut it back so much that it left the Streamlight part of the holster out on it's own and prone to breaking.  

  To assemble this, use #8-32 Button head screws and either nylock nuts or regular nuts.  The insets in the holster are deep enough that Nylock nuts should work.  I'm using ones 11/16ths long when tieing it into my Parametric AX Mount setups to use in my competition rig.  You'll want one close to an inch long to use for the tensioning screw.  

  All of this is because of you guys downloading and boosting.  Next up is a Target Paster device for use on the range, and then I guess I need to convert this design to IWB, then start moving the TLR-1 down through my other guns, including my M&P and PDP designs.  Or jump right to the X300.  We'll see where it goes.  Thanks for all the support guys.  Any comments, critiques, requests, all of that is welcome.  Thanks again.

2/15/26 UPDATE: The IWB Version of this holster is now available, here