RG-477m Grip

Hand Grip for the Anbernic RG-477m. This low profile design give the best feeling grip with a fast print time. Handles are deep and flair out 20 Degrees and extend ⅓" below to comfortably fit your hand posture. Middle finger rest on the back shelf gives the best secure grip when shoulder buttons are needs, or use it as a pointer finger shelf when only needing the d-pad and face buttons.

Print settings used for a good result in under 7 hours:

Cura 5.11
Ender 3
Layer Height: 0.22
Top/Bottom Thickness: 0.8, 3 layers each
Infill: 15% Cubic
Print Temp: 205
Plate Temp: 55
Print Speed: 45
Support: Normal, Touching buildplate, 75deg overhand, 1.5mm support expansion
Model rotated 45degrees (Z-axis), positioning the model across plate corners for best fit (see pic).