Search models, users, collections, and posts
Arduino Uno Case w/ Breadborad Insert
Remixed by
IP Report
Print Profile(4)
0.16mm layer, 4 walls, 15% infill
3.3 h
3 plates
A1 Mini, Arduino logo on lid, 0.16mm layer, 4 walls, 25% infill
4.2 h
3 plates
0.2mm layer, 4 walls, 15% infill
2.4 h
1 plate
Arduino cover with adapter holder
48 min
1 plate
Open in Bambu Studio
Boost
1042
2523
170
158
2.9 k
1.6 k
Released
Description
This is a remix of Arduino Case by 3DP. I've added a button to access the reset switch, removed excess material to make it slightly thinner, added a groove between the top case and lid to prevent any possible wobble, widen the tolerance to 0.35mm around ports, and did some cosmetic changes.
Print Settings
- .3mm layer height
- Infill 25%+
Assembly Hardware
- 4 M3 x 12mm screws for the bottom and top case
- 6 M3 x 16mm screws for hinges
- 3 M3 x 5mm screws for mounting Arduino
Inserting the breadboard is a tight fit. For easy installation line up the breadboard so that it's parallel to the opening and apply even pressure, and you shouldn't have to trim down the nubs on the breadboard.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (170)