Super Strong Backpack Hanger | Wall & Desk Mount

The Only Hook You Need 🎒

Stop tripping over your bag! This Super Strong Backpack Hanger is the ultimate solution to declutter your workspace.

Unlike standard hooks that snap under load, this model features a reinforced triangular geometry designed to handle heavy backpacks, laptop bags, headphones, or VR headsets without flexing.

✨ Key Features

• Universal Mount: Works perfectly under a desk (hidden & clean) or on a wall (easy access).
• Heavy Duty: Designed to hold heavy loads comfortably.
• Secure Lip: The angled tip ensures your bag straps won't slide off accidentally.
• Single Screw Setup: Installs in seconds with minimal tools.

Printing Tips (Important!)

For maximum strength, follow these settings:

• Orientation: Print on its SIDE. This is critical so the layer lines run along the length of the hook.
• Material: PLA, PLA Tough+, PETG.
• Infill: 25% or more (Gyroid pattern recommended).
• Layer height: 0,20 mm Strength.
• Walls: 6 for extra durability.
• Top shell layers: 4.
• Bottom shell layers: 4.

🛠️ Bill of Materials (BOM)

To install this hook, you will need:

• 1x PZ screws with a cylindrical head: 3.5 x 30mm
• 1x Wall Plug / Anchor (For wall mounting).
  • Recommendation: Use a standard plug matching the 3.5mm screw.
• ⚠️ Warning for Desk Mounting: If mounting under a desk, check your desk thickness! A 30mm screw is likely too long for standard desks (18-25mm). Use a shorter screw or washers to avoid piercing the tabletop.