Reze Hueforge

**IMPORTANT INFORMATION**
You cannot adjust the z scaling on any hueforge. This will mess with the coloring done and your hueforge will not come out as intended. You can however change the x and y to scale the picture. I recommend only changing by the same percentage.
To get an accurate print as shown in the photos you MUST use the same filaments listed below. You can change brands (as long as they are similar) but keep the filament colors the same. If you use any other color, you will not get the same results as me.
What you see in the slicer will not be how the final results will look! Hueforge takes advantage of color bleed to make the blended colors!
 

I have added pauses for color swaps for those with only one ams!!

If you enjoy my work or are looking for something different, consider joining my Patreon! I upload all my files there and offer different membership tiers.
www.patreon.com/MonkeyForge3D

Follow the instructions given below if you are not using my 3mf file.

Please use the same filaments for accurate results! I cannot guarantee same results if you are using different brands

Project: Reze Chainsaw Man.hfp

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 188x235mm in size

You may print at higher layer heights below the Base Thickness of 0.96mm

The Max allowed Thickness is 3.92mm and the Actual Thickness is 3.28mm

Filaments Used:

#000000 PLA BambuLab Basic Black Transmission Distance: 0.6

#00358e PLA BambuLab Basic Blue Transmission Distance: 4

#482960 PLA BambuLab Basic Indigo Purple Transmission Distance: 1.1

#3f8e43 PLA BambuLab Basic Mistletoe Green Transmission Distance: 1

#de4343 PLA BambuLab Matte Scarlet Red Transmission Distance: 2

#ae96d4 PLA BambuLab Matte Lilac Purple Transmission Distance: 2

#fec600 PLA BambuLab Basic Sunflower Yellow Transmission Distance: 4.4

#ffffff PLA BambuLab Matte Ivory White Transmission Distance: 3.2

This print uses 8 unique filaments

Swap Instructions:

Start with Black

At layer #18 (1.52mm) swap to Blue

At layer #22 (1.84mm) swap to Indigo Purple

At layer #26 (2.16mm) swap to Mistletoe Green

At layer #28 (2.32mm) swap to Scarlet Red

At layer #30 (2.48mm) swap to Lilac Purple

At layer #33 (2.72mm) swap to Sunflower Yellow

At layer #37 (3.04mm) swap to Ivory White

This slider is set higher than the mesh depth. It is not affecting your final mesh. Consider removing it.

Border Only Colors from here until the end.

At layer #47 (3.84mm) swap to Black for the rest.