T45-T60 Power Armor Helmet -Can Holder (Two types)

T45-T60 Power Armor Helmet - Can Holder (Two types)

• These helmets are a mix between T-45 and T-60 power armor from the Fallout Game and TV series, I'm afraid not all the details will be completely accurate.
• Fits long EU cans with a capacity of 0.5L. You can also use my insert for 12oz or 330ml (slim) cans (link below)
• Recommended print settings: PLA, 0.2mm layers, 2walls, 8%gyroid, brim, Automatic (30°) tree support, It is necessary to set supports even under some small parts and tubes.
• Or just use my profile :)
• Remove the supports wisely, very carefully, and ideally with pliers. It is better to spend 5 minutes removing the supports than to have a ruined piece.

#1

#2

Here is the link to my model of the insert that you can use in 0.5L holders with your 12oz , or 330ml slim cans, and 10mm riser if you want better access to the top. They are scalable, so you can make them smaller or larger in your slicer.

https://makerworld.com/cs/models/1499777-can-holder-riser-inserts-12oz-slim-330ml-scalable#profileId-1568806

Happy printing:)