Cardcaptor Sakura Star Staff MAX-PIKA

Original creation, commercial use prohibited!

The highly anticipated Star Staff 1:1 scale version is here now!

-----------------------

Cardcaptor Sakura Bird Head StaffMAX features:

1. Total length over 1.1 meters, life-size height

2. Pole length can be freely adjusted, the pole can be 3D Printed, replaceable stainless steel tube

3. Universal thread, supports expansion (e.g., expanding into a broom, feather duster, etc., let your imagination run wild)

4. You'll need to have a barbecue to get the hardware (barbecue skewers), or you can directly purchase 1mm barbecue skewers (specific assembly method below)

5. Support optimized, foolproof design, easy assembly

-----------------------

MINI version Star Staff portal, click image to go directly:

Given the expectations of many friends in the comments section of the Bird Head Staff, I researched all Star Staffs on the market and created this magic staff.

Currently, most Star Staffs on the market have cute wings, so based on the original animation, I decided to use the expanded wing form!

Perfectly restored according to the original animation, pure original design, full of details, and the star can rotate!

Star and decorative connectors: Silk Gold
Diamond: Silk Red
Wings: Matte White
Pole and ring: Lotus Pink (third-party filament pink)

Platemaking and supports have been optimized, supports one-click printing from mobile phone

Different filaments have different sinkage rates, if the threads are loose, it's recommended to apply some super glue!

Assembly steps are as follows:

1. Print to get all parts:

2. First, use glue to attach the red parts to the upper and lower connectors

3. Have a barbecue, or order barbecue takeout, or ask for one at a barbecue stand (for extroverts), to get a 1mm iron skewer (or directly buy 1mm barbecue skewers online)

4. Use pliers to cut two 5cm segments from the iron skewer

5. Align the star's pointed end with the hole in the upper part of the ring (the side without threads) and insert a segment of iron skewer

6. Similarly, insert the bottom iron skewer into the hole

7. Screw on the upper connector, check if the star can rotate, if it can, drop a bit of glue at the top iron skewer

*If the connector is not parallel to the ring here (usually due to different sinkage rates of filaments), you can apply glue to the threads and adjust it to be parallel

8. Install the wings, note to install the bottom first, then the top, the wings are not left or right specific, applying glue here is recommended. Head assembly complete!

9. Screw on the threads of the head, pole, and tail, matching them one by one

*Explanation of special cases:

90% of barbecue skewers will meet the requirements and can be used directly with the printed parts.

【Solution for iron skewers being too thick to fit】

If conditions allow, please manually measure the diameter of the iron skewer and try to adjust the hole compensation value for the star and ring assembly; adjust by the amount it is larger

(e.g., if the measured diameter is 1.5mm, modify this value to 0.5mm)

If you cannot measure, it is recommended to directly adjust to 0.5mm and try.

【Regarding if you plan to use it for sweeping or pursue higher strength, or want a seamless pole】

Refer to the instructions regarding the pole hardware section after the text in Cardcaptor Sakura Bird Head Staff MAX-PIKA

Display!

Welcome to check out my other works on my homepage, click the image to go directly: