Easy-Grip Ring Pull Helper, Tab Puller
Print Profile(1)
Description
Tired of hurting your fingernails or struggling with tight can tabs? This is a simple, ergonomic tool designed to open any ring-pull can (soda, soup, pet food, tuna) with ease.
Recomended material: Petg
I have prepared two separate print plates for your convenience:
- Standard Version: without magnets.
- Magnet Version: Designed for a D10 x 1.5mm round magnet.
Important - Magnet Installation: For the magnet version, I have pre-configured a pause at Layer 14. When the printer pauses, simply drop the magnet into the slot and resume the print. The magnet will be fully encased (hidden) inside the tool for a sleek look!
Support Information: I have optimized the supports to be as easy to remove as possible. However, I still recommend being careful when removing them from the opener.
Tip: Use a thin, hard tool (like a small flathead screwdriver, tweezers, or a hobby knife) to gently pry the support material out of the opening.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (14)