Search models, users, collections, and posts
Press fit pips
Remixed by
IP Report
Print Profile(1)
0.28mm layer, 2 walls, 15% infill
Designer
10 min
1 plate
Open in Bambu Studio
Boost
2
1
0
0
1
2
Released
Description
I created these to press into the spot where the original create had white pips. This avoids color swaps. The end result is the pips are slightly raised. I added a chamfer on the bottom to make it easier to press in. I also added a slight round recess on the bottom so you can readily tell which side is the bottom.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)