Search models, users, collections, and posts
32" Twisted Hobbys Crack Yak Wheel Pants
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 8% infill
Designer
28 min
1 plate
Open in Bambu Studio
Boost
2
4
0
0
2
0
Released
Description
Wheel pants for the 32" Twisted Hobbys Crack Yak. My foam ones always kept falling off, printed these out of ASA for UV protection and low weight. Might work fine in PETG as well, be a bit heavier. You will have to drill a second 2mm hole in each side to install these.
Requires: 6x M2 Nuts, 2x M2x12, 2x M2x4
License
This user content is licensed under a Standard Digital File License.
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (0)