Ninja AF10 Air Fryer Exhaust Flange - 3" Exhaust

I am by no means a mechanical engineer so use at your own risk. Cross sectional area of the exhaust piping exceeds that of the original exhaust, so it's good enough in my eyes. I'm using my air fryer as a filament dryer stored in my office, so I wanted a way to extract the heat/fumes from my space. I would not suggest this for cooking food. 

THIS IS FOR AN AIR FRYER USED AS A FILAMENT DRYER

I highly suggest using nylon filament or ABS/ASA at the very least. My model is simply a proof of concept and has been printed in PLA. Surface finish can be greatly improved, the photos are printed in 0.28mm layer on a factory configuration. Please adjust your configuration according to your chosen filament.

Once I get some PA filament and print this with good settings, I will likely update this with a proper configuration. Until then, settings are up to you. Please feel free to provide feedback on either the model or settings if and when applicable.

Model number: AF10 Series U7

May work for other similar models