What If...Mjolnir was an Axe?

What if Thor wielded Mjolnir as an axe instead of a hammer?

This is very simple print and assembly. Everything prints without supports and assembles without the need for glue. You don't need an AMS (though you will need to insert your own pause on one plate if you don't have one and want the color or strength of the inner rod to be different than the part that can be seen).

After printing, add a handle section to the lower inner screw and push it down to the top of the thread. Then add two connector pieces into the top slots and slide down a handle rib over the connectors. Add another handle piece and alternate like this until there are no more pieces. Near the top the last few sections will not be supported by the inner handle screw.

Once all the handle pieces are in place, add the final two connector pieces and put on the inner head part. Carefully balance this and slide this inside the axe head. From the top push down the upper inner screw and thread it into the lower inner screw. Finally screw on the pommel while pressing the upper inner screw against the top of the axe head which will bring everything to tightness.