KOENIGSEGG JESKO

The Koenigsegg Jesko!

Please follow the 3mf file settings when printing, they are carefully thought out and tested. That ensures good quality. Please remove the supports carefully and calmly. The spoiler or the side mirrors might get damaged otherwise. 

ASSEMBLY:

The tires are very tight, so you need to apply some pressure. Easiest way is to add tires to both sides at the same time, and one finger to both, and squeeze. They should just snap on if you're using the right amount of force. The tires being separate of course adds the possibility to print them as different colors!

PRINTING:

If you print via the STL file, you should follow these instructions:

• Only PLA is a tested to work material: Others might work and probably do, but I make no promises.
• Make sure that your slicer creates supports for the axles for each wheel.
• Use slow overhang speeds.
• Use tree support style.
• 15% infill is excessive, use 5-10%.
• Layer height 0.08mm (or even smaller).

Please make sure your bed is clean so the print will have a higher chance of adhering correctly. Otherwise the tires might turn to spaghetti and in worst case ruin the car itself.

The cover photo is AI enhanced, i changed the filament color from gray to matte black. It has not been touched to make the results look better than reality: My print did look like in the cover, just gray.

The car in the model has been made in MW image to model AI. This causes the backside to look more like an Mclaren than a Koenigsegg. Sorry for the confusion this might cause.

Thank you for choosing my model! Commenting your results is appreciated.

- toilet-sensei