MAG wallet pro- the first magnet based wallet

MAG Wallet PRO
The MAG Wallet PRO builds on the original MAG design with a built-in lanyard ring and the new MAG-Lock system. MAG-Lock allows modular magnetic accessories like a cash clip, cash sleeve, or coin and key compartment to magnetically attach and detach as needed.

The magnetic lid stays locked when closed and snaps cleanly to the side when open for quick access. Slim, lightweight, and modular, the MAG Wallet PRO is made for everyday carry without the clutter.


The story of the MAG wallet series 

I have always loved using 3d printed wallets i even liked them more than my real ones but they all had one problem these little clips that hold the cards in there always wear out and i have to reprint the entire thing. So i set off to design my own card wallet after a few hours i came up with the MAG wallet and quickly discovered tolerances. then after like 8 slight changes i finished and uploaded it here the i gave a few to some friends to try out and review the first thing anyone told me was “THAT HUGE” so i went to the desk and got back to work and redesigned the entire thing with one goal in mind make it smaller and created the MAG wallet slim only 6mm thin and i loved it only positive feedback. so done, right? no i new there was room for improvement so i went around asking people what do you want to see in a card wallet, the main things i got was lanyard clip, cash clips, cash sleeves, and for some reason a baby carrier. I wanted to put all that in the design (except the baby carrier) but how do you put a cash sleeve and a cash clip on the same wallet? The solution is simple, the MAG lock, basically 4 magnets that attach to magnetic accessories. AND after 3 weeks i perfected the mag wallet with the MAG wallet pro.
 

if you want to make your own mag lock accessory use this reference photo for correct magnet spacing.

recommended settings and filament 
I recommend using bambu lab PLA basic and PETG HF 

use my defalt print profile it has the right infil and supports that I used 

parts needed 
you will need 22 5x2 disk magnets 

It might seem like a lot but it will be worth it.

hope you enjoy using the mag wallet and find it useful. If you have any suggestions for new accessory's or updates drop a comment below!  

update V1.2 added plain back panel

update V1.3 fixed tolerances on magnets 

Check out more of my models and follow for weekly uploads!