Search models, users, collections, and posts
Heatmiser neoAir Thermostat Desk Stand
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 10% infill
Designer
1.6 h
1 plate
Open in Bambu Studio
Boost
6
3
0
0
10
8
Released
Description
Desk stand for a Heatmiser neoAir wireless thermostat.
If you don't want these on the wall, the official stand doesn't look very strong and price is ridiculous. This may fit some previous models but you'll have to check the measurements of the slots on the back.
Separated the sliding section that attaches to the thermostat and the main stand for easier orientation. Also will make it easier to replace the batteries. Slide the profile onto the back and then it should be an easy press fit to the main stand. You may need to tweak the fit of the pieces together depending on your filament. I think the sliding panel is undersized around 0.15mm currently and it presses together firmly.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)