Search models, users, collections, and posts
Shure MV6 Pole Mount
IP Report
Print Profile(1)
0.2mm layer, 4 walls, 15% infill
Designer
1.2 h
1 plate
Open in Bambu Studio
Boost
1
3
0
0
5
3
Released
Description
The mic is angled up at 25deg from the pole. The mount is designed for poles with a diameter of ~35mm. You should print in something less stiff than PLA (i.e. PETG or ASA) if you've got to "snap" the opening around a pole and can't guide it over the top.
BOM:
- 2x M3 square nuts (~1.6mm deep)
- 2x M3 bolts 20mm (minimum)
Boost Me (for free)
Thanks for checking out my model, don't forget to leave a boost if you think it deserves it! <3
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (0)