Search models, users, collections, and posts
Music stand clip on tray table
IP Report
Print Profile(1)
0.2mm layer, 4 walls, 15% infill
Designer
2.2 h
1 plate
Open in Bambu Studio
Boost
26
91
0
0
31
24
Released
Description
A clip on tray for music stands.
It easily clips onto a music stand or other tubes with a 25mm diameter and fits onto 18x18cm print beds like the bambu a1 mini. Great place to put your plectrum, silencer, wax or a tuner and pen, anything that doesn't fit on the bottom of the stand anymore.
- Easy to clip on and off with feathered clip
- Prints in place
- No assembly or glue required
- Printed in PLA
- Prints in just 2 hours
Feel free to resize it up or down if your music stand is wider or thinner. Make sure to use the exact measure of the stand since the feathered clip on mechanism will fit snug, so for a 25mm it is exactly 25mm on the inner diameter, for 35mm it would be exactly 35mm on the inner diameter of the clip
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)