CableLoop for OpenGrid Underware - Free 3D Print Model

Search models, users, collections, and posts

Remixed by

blakeawesley

Household>Office

IP Report

Print Profile(1)

All

X1 Carbon

P2S

P1S

H2D

H2S

H2C

X1E

H2D Pro

X2D

P1P

A2L

0.2mm layer, 3 walls, 15% infill

Designer

26.7 h

25 plates

5.0(50)

Open in Bambu Studio

Boost

257

1374

1.7 k

1.2 k

Released

Bill of Materials

Bambu Filaments

Select all

PLA Basic

PLA Basic

Description

The CableLoop is designed for organizing your longer cables as part of the Underware system. The model by JoshPrints was for MultiGrid but I have remixed it to work for openGrid.

I totally remade the models to create two types: 3x3 for smaller/shorter cable loops and 6x3 for the longer cables.

To use them, you install the snap in the middle of the 3x3 (two snaps for the 6x3, with some separation) and screw in the stud. The stud has some ‘wings’ to help your cable stay in place while you wind it around and then install the cover.

There are a variety of inlet and outlet options:

3x3
- Straight
- U-Turn
- 90° Bend
- Square (cut the tabs to decide which gates to open)
6x3
- Straight
- U-Turn
- 90° Bend (plus a mirrored version)
- S-bend (plus a mirrored version)
- H
- Multi (cut the thin walls to decide which gates to open)

On top of the above variations, there is also a ‘Thin’ version which was designed to print a bit faster and save some filament. HOWEVER, I don't recommend using these ones as the holding strength is quite a bit lower. So print these types at your own risk and still give me 5 stars (lol). That said, I have printed some of these (the more see through ones).

I've added text to the print profile so that you can print a label on the first layer in a different colour if you wish. Of course, you don't have to and can just change the print colour to the same colour as the base colour, or simply delete the text if you don't want to print with a label.

As far as materials, I printed all of mine in PLA and it seems to hold up really well. I'm sure PETG, ABS and some others are probably good options too.

Changelog

v1.2 - 2026.05.09

Added square 3x3 model. ‘Gates’ to be cut as required depending on use case.

Renamed plates containing ‘Lite’ to ‘Thin’ to signify that these are thinner variants, not OG-Lite specific variants.

v1.1 - 2026.02.08

Added shortened stud for openGrid Lite, and openGrid Lite snap on new plate.

v1.0 - 2026.01.22

Initial Release