Say 6 7 Again Bookmark

UPDATE  Added a single layer of white under the Orange sections to lighten up the color.

Jules had enough of this BS.  If you don't stop you may find yourself… 6 - 7 feet under.

This will be my last model based on this silly meme, but I had this idea and had to run with it.  Didn't want to get too dark so I replaced his pew pew with a water pew pew.

This model requires at least one AMS to print and I'll give the the instructions on how to print it.  You will need 6 colors of PLA; I used Bambu Lab Basic PLA in Jade White, Black, Brown, Cyan, Orange and Yellow.  The Teal and Grey sections are just thin layers of White over base colors.

Load the first four colors in the AMS, reserving the Orange and Yellow for later.  There is a pause set in the print at layer 6 to swap out the filaments that will occur in about 50 minutes.  When the pause occurs replace the Black with the Orange.  Resume the print and WAIT for the last layer of Brown to print, the filament to unload from the extruder, and THEN swap the Brown filament with the Yellow.  There is no second pause to swap the Yellow, just don't dilly dally.  Easy peasy.

If you have two AMS's just load all the filaments and change the Orange and Yellow objects in Bambu Studio to the appropriate filament slot.

Happy printing!