Arduino UNO Case – Bottom Part (Snap-Fit)

This model is the bottom part of an Arduino enclosure, designed for quick and tool-free installation.
To install, simply snap the Arduino board into place — no screws or tools required.

Features:

• Snap-fit mounting – holds the Arduino securely without screws
• Alignment posts – ensure correct positioning of the board
• Connector cutouts (USB / power)
• Strong and simple design
• No supports required for printing

The Arduino is firmly held by integrated clips, while still allowing easy removal if needed.

🖨 Recommended Print Settings

• Material: PLA / PETG
• Layer height: 0.2 mm
• Infill: 15%
• Supports: No
• Orientation: Bottom side down

⚠️ Note

• Installation: just snap the Arduino into place
• No screws or tools required
• This is the bottom part only – top cover not included