Fanntik V8/10 slim Apex storage and charging frame

Charging Cradle Fanttik V8 Apex Slim

I bought the Fanttik Slim V8 Apex for cleaning my 3D printer and other devices. Unfortunately, nothing is included for storing the accessories. I designed a storage frame that accommodates most of the parts. The V8 charges when it is in the stand. I printed the stand in PLA. Kojak used Version 1 of the model with the V10. Version 2 should also be compatible with the V10. It would be great if someone could try it.
 

Version 1 with Adapter Plug

This version can also be used without a charging port. In that case, the installation of the charging port is omitted.

For the charging connection, I used a JSAUX USB C 90-degree angled plug.

I found that the included charging cable only charges at 1.2A. With a USB-C PD cable, the V8 charges at 3A.

Assembly:

The stand can also be used without a charging port. In that case, the installation of the charging port is omitted.

The 90-degree plug is inserted into the holder. Then, the plug retainer is inserted into the guide slots of the holder. Now, the holder is carefully screwed onto the charging cradle with the M2x8mm screws. Tightening too much will strip it! The charging cable is connected to the output of the angled plug.

Required Parts:

• 1 x JSAUX USB C 90-degree Angled Plug Amazon ASIN: B0B77CJD7T
• 2 x round head self-tapping screw M2*8mm for mounting the angled plug
• 3 x round head self-tapping screw M3*16mm for wall mounting

Version 2 for Original Cable

Here, the adapter plug is omitted. The cable is inserted into the bottom part, and the plug is inserted from above until it goes no further. Now, the clamping fixation in the guide is pressed against the cable's strain relief and snapped into the bottom part. Afterward, the bottom part is mounted into the base and fixed by twisting.

04.02.2026 - Added version for the included charging cable

06.02.2026 - Small optimization of the base and cable holder for Version 2

10.02.2026 - Version 2 adapted for the Skadis system and minor optimizations. Skadis mounting part added.

20.03.2026 - Added compatibility for V10 Apex Slim.