Toyota Lexus RX300 Door/Window Rocker Switch Clip

***PLEASE CLEAN YOUR BED PROPERLY BEFORE PRINTING. DAWN DISH SOAP(Or Equivalent) AND HOT WATER THEN DRY WITH PAPER TOWEL OR AIR DRY!! NOTHING ELSE NEEDED!! THIS WILL ENSURE YOUR PRINT IS SUCCESSFUL***

##  These models printed as shown but if you dont clean your bed properly and have adhesion issues, then you can add a brim or mouse ears. I test all my prints and it is proven to print as I set it up. ##

MUST PRINT IN .08MM layers Very SMALL AND FINE DETAILS

My window switches in my Lexus RX300 were not working properly after tearing down the switches i noticed these little rocker clips had broken the legs off so they wouldnt hold the switched in position anymore.

I designed these in Tinkercad almost to spec. and they worked to repair my switches, hopefully it can help others with the similar switch, may fit toyota highlander as the RX300 shares parts in some years.

I printed the first few in a lying down position with 999 walls to make them solid but the support was hard to remove without breaking the legs. This upright orientation printed well although it may be weaker as the layers run horizontally but this little piece actually has very little horizontal stress since it pushes downward mostly. Fell free to experiment with other print orientations if this doesnt work for you.

2nd plate is for the little push pins that go under the rubber membrane to push down the contacts, if you dont need them disregard.