Otter with the special extra
Print Profile(1)
Description
This little otter doesn't just happen to come with a red button.
He's cute, cheeky, a little mysterious – and has a special extra inside.
The figure has an integrated compartment for a magic audio chip insert.
Depending on the printer and material, I recommend slightly re-working the hole with an 8mm drill bit or alternatively enlarging the diameter in the slicer by approx. 0.1 mm so that the insert fits properly.
Additionally, there is room for two magnets:
- 6 mm diameter
- 3 mm height
For the magnets, a print pause must be set in the slicer at the appropriate height.
The magnets are pressed in during the pause and then printing continues.
The red button is, of course, just decoration.
What the otter can really do is ultimately up to everyone to decide 😉
🔧 Note on the insert
Here you can find the corresponding insert for the magic audio chip:
👉 https://makerworld.com/en/models/1270297-magic-audio-chip-sleeve#profileId-1296834
🖨️ Print Notes
- For private use only
- Easy to print
- Print pause required for magnets
- Child-friendly design
- Ideal as a small surprise or decoration
Have fun printing – and causing otter mischief 🦦❤️
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (0)