Low-Profile IKEA Metod Cabinet Feet (5-10-15-20mm)

Protect your IKEA Metod cabinets from floor moisture without sacrificing that sleek, minimalist look! I designed these low-profile feet to get your cabinets as close to the ground as possible while keeping the vulnerable particle board safely off the floor. Whether you're worried about wet mopping or accidental spills, these feet provide the perfect protective barrier.

Dimensions & Options This model includes four different height variations to dial in your exact clearance:

• Available Heights: 5mm, 10mm, 15mm, and 20mm.
• Peg Size: Designed for the standard 10mm factory holes on Metod frames.
• Pro Tip (Print Settings): Because these support heavy furniture, strength is critical. I highly recommend using PETG or tough PLA+, with 3 to 4 wall loops (perimeters) and at least 20% Gyroid infill. No supports needed!

Key Features

• Hardware-Free Friction Fit: Engineered to press-fit tightly right into the existing holes on the bottom of the frame. No screws needed.
• Perfect Door Clearance: The profile is low, but it accounts for the door swing—ensuring bottom drawers and doors open fully without scraping your floor.
• Maximum Stability: Features a wide, flat bottom design that provides plenty of surface area to distribute the weight of loaded cabinets evenly.
• Easy Installation: Just push them in! (Maker tip: Tolerances vary by printer. If the fit is slightly too tight, just scale the model down by 0.5% in your slicer or give the pegs a quick scrape).

If you find this model useful, please consider leaving a ⭐️⭐️⭐️⭐️⭐️ review or a Boost! Happy building!