IKEA Flisat ClipOn Hooks for Jackets + Hats/Gloves

These clip-on hooks turn the IKEA FLISAT wall storage into a neat little kids’ entry station: jackets go on the hooks, while hats, gloves and small items can sit on top without sliding out so easily.

Features

• Clip-on design: no screws, no glue, no permanent changes

• Dual purpose: Works as coat hook and as a front guard at the same time

• Great for kids’ rooms, entryways, daycare corners, etc.

How it works

• Unscrew the front rod from the FLISAT

• Put the clips onto the front rod

• Screw the front rod back onto the FLISAT

Printing tips (general)

• PLA works for light kids jackets; PETG is better for toughness

• Increase perimeters/infill if you expect heavier loads

• I used

  • Material: PLA

  • Perimeters: 6

  • Infill: 20%

Fit note (important)
FLISAT rods aren’t always the same thickness along the length. The clip opening is sized so it can pass the thickest section (at least on my FLISAT). That means it may feel a bit looser on thinner sections depending on your unit and printer tolerances.