H2 Honeycomb Door Handle for Bambu Lab H2C/H2D/H2S
Print Profile(1)
Description
Honeycomb door handle replacement for Bambu Lab H2C, H2D, and H2S.
Intended as a simple swap for the stock handle. Utilizes the two screws from the original door handle.
Increased width and offset from the door makes it usable as an actual handle instead of a pull tab.
Very low filament usage and a fast print with no supports required.
Tested in PLA and PETG.
Boost Me (for free)
Dig the model? Say thanks by boosting me for free!
Installation
[Requires a 2 mm hex wrench]
- Remove the two screws holding the stock handle and remove the handle.
- Pre-thread the new handle before installation:
- Hold the handle and press the screws in by hand while turning them until they start to bite.
- Use a hex wrench to thread each screw in about halfway.
- Remove the screws.
- Align the handle with the holes in the glass and thread the screws in from the opposite side of the door.
- Tighten until snug. Do not overtighten. Stop once the screw contacts the silicone spacer and the handle feels solid.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (24)