Ultra-Fast Toy Propeller (2 Min Print | 0.39g)
Print Profile(1)
Description
đ Ultra-Fast Toy Propeller (Gravity Helicopter)
Looking for a quick print that is actually fun? This toy propeller prints in just 2 minutes and uses almost no filament!
It is based on the classic paper helicopter design. Simply drop it from a high place, and watch it spin gracefully to the ground. It demonstrates the principles of gravity and air resistance, making it a great little STEM toy.
⨠Key Features
- Super Fast: Prints in approximately 2m 10s.
- Micro Filament Usage: Uses only 0.39g of filament! Perfect for using up those last few meters on a spool (Scrap Buster).
- Zero Waste: No supports required.
- Simple Assembly: Just print and bend.
âď¸ Print Settings
- Material: PLA, PETG, ABS (PLA or ABS recommended for stiffness).
- Layer Height: 0.16mm
- Infill: 100% (It is thin, so infill doesn't matter much).
- Supports: None.
đ ď¸ Post-Processing (Important!)
After printing, the model will be flat like a 'Y' shape.
- Take the model off the build plate.
- Bend the two wings in opposite directions.
- Long Wing: Bend the longer wing **60~70 degrees** in the **SAME** direction as the bottom protruding weight.Â
- Short Wing: Bend the shorter wing **60~70 degrees** in the **OPPOSITE** direction.
- Drop it and have fun!
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (0)