Double-ended Fidget Clicker

Double-ended Fidget Clicker.

A winner anywhere. The double click per single press feels and sounds so satisfying

A fun little toy to mess around with. Only ~8g per print.

A few options available:

• the minimalist profile which is a basic as it gets with just a little less than 8g of filament used. 
• the textured profile which is a little better looking and feels much nicer. Uses a little bit over 8g of filament.
• the fuzzy profile which is a you could guess, is painted with fuzzy layer and uses a little bit less than 8g of filament.

Make sure that all prints have the supports enabled.

This fidget required 2 keyboard switches to operate. If you reside in Australia, you can purchase some key switches here and help support local creators: ClickKey Store 

A small amount of glue may be required to hold the keyboard switches in place depending on your model and type.

Can be used as a flush object when printing multi-colour prints and you want to reduce waste filament. 

Select: flush into objects infill, flush into object, flush into objects support in the Others tab or the Flush Options on each object individually.

Allow supports for the centre piece. 

If you find this useful, feel free to give the model a rating or boost.

You can find more fidget clickers created by ClickKey here