Search models, users, collections, and posts
Outdoor Case for MOES ZIGBEE Door Sensor ZSS-GWM-C
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 4 walls, 25% infill
Designer
35 min
1 plate
Open in Bambu Studio
Boost
3
5
1
0
5
3
Released
Description
base: 2,5mm walls 1,2mm
Remixed for moes sensor, i'm using it to check if my gate status for HA automations. it's quite tight and cover will not fall - the holle on the bottom was designet to place a screw but seems that i dont need it but maybe the moisture will came out better.
Printed using PLA for testing next i'll use PETG for outdoor.
On the left side I placed guides for M3 screws. i used rivet nut in gate and want to make left/right adjustments.
This sensor is very is very sensitive in this case and original magnet it senses in the distance of about 1cm
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (1)