Search models, users, collections, and posts
Volvo gas cap retention strap
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
22 min
1 plate
Open in Bambu Studio
Boost
6
15
0
0
7
5
Released
Bill of Materials
Bambu Filaments
Select all
Description
My original volvo retention strap on my 2002 S60 finally broke, so I decided to print one in TPU.
In order to assemble, you have to push out the two pins holding the old strap on the ring. Keep the old ring in place, and then put in the printed part from this model, and fit in the pins again. Might take a tool like tweezers or a small screwdriver to push the pins.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)