EGO SNT240X SnowBlower Chute Upg: 5 to 7 Positions
Print Profile(1)
Description
Boost Me (for free)
If this 3D-printed repair saved your day (and your wallet!), please consider supporting my work with a Boost. I'm just starting out on MakerWorld and every bit of support helps me create more rugged, real-world solutions. Thank you! šŖ
šEGO Snow Blower Chute Upgrade: 5 to 7 Positionsš
Upgrade for the chute control plate on EGO dual-stage snow blowers (SNT240X series).
Compatible for SNT2400 series (SNT2400,SNT2405,SNT2406)
If you are like me and was putting the knob between 2 notches, then this is the part for you.
- The Change: Replaces the original 5-position metal plate with a 7-position design.
- The Advantage: Provides two extra notches for much finer control of the snow discharge angle.
- Material: Printed in PA6-GF (Glass Fiber Reinforced Nylon).Ā
- Note : I would use GREEN/Lime if I had š¤·
- Durability: Extremely solid and wear-resistant, doesn't match the strength of the original metal part but with PA6-GF, I assume it will be better than PETG
- Settings: Printed at 100% infill for maximum structural integrity.
- Installation: Direct replacement using the original screws.
You can see the original metal part and all the test parts I did to make it fit š
Installation Instructions
The installation is a quick and direct swap:
- Remove the Handle: Remove the 2 screws located on the side of the green handle to slide it off the metal lever.
- Remove the Plate: Remove the 2 screws holding the original metal plate in place.
- Swap & Reassemble: Place your new 7-position plate, reinstall the plate screws, slide the handle back on, and secure it with its 2 screws.
- Tool Required: A Torx T20 screwdriver is typically required for these screws.
Boost Me (for free)
If this 3D-printed repair saved your day (and your wallet!), please consider supporting my work with a Boost. I'm just starting out on MakerWorld and every bit of support helps me create more rugged, real-world solutions. Thank you! šŖ
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (0)