H&K VP9 Airsoft Charging Supports
Print Profile(1)
Description
Charging supports for the slide of the H&K VP9 Airsoft pistol by VFC/Umarex.
I printed these with an 0.2 nozzle and coolplate, I advice to do the same yet I do think it could still work with an 0.4 nozzle and a brim.
They are quite difficult to get in, but this is on purpose so that they fit properly and won't come out to easily
Installation guide:
- To install the ears you first want to take out the 2 screws on the inside of the slide that hold down the rear Iron sight.
- Then without taking it off tilt/pull up on the rear post, this way you should create a small gap between the slide and the iron.
- Take out the remainders of the original ears (If there is anything left).
- Then under an angel insert the ears between the slide and sight post do this carefully, this should not be forced.
- Pivot the ears down so that the pin aligns with the whole and press firmly.
Look closely on which side which ear should go.
I also made one without the ears:
https://makerworld.com/en/models/2244867-h-k-vp9-airsoft-charging-support-flat-removed#profileId-2444038
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (0)