Flashbang Stun Grenade | New Design (v2)

Summary

The all new Flashbang you've asked for is finally here!  This Flashbang is redesigned from the ground up with more details and a realistic screw-on top, just like the real thing.  This version includes the option for a plastic spring in addition to the metal spring option.  The plastic spring can be easily swapped out, so you never have to worry about your plastic spring wearing out.

Spring options (for flying handle)

1. Metal Spring (recommended) – if you have a metal spring, even a pen spring will usually work, then print the metal spring profile.  It is designed to work with the Bambu Store's 0.5x7x12mm spring (linked lower on the page).  If you use a pen spring, you can usually cut it in half and get two springs.
2. Plastic Spring – if you don't have a metal spring, but still want the handle to fly off, then print the plastic spring profile.
   1. If the spring eventually wears out, just print a new one and pop it in.
   2. Don't leave the spring under tension when not using it as it will wear out much faster.
   3. Avoid Matte and Silk filament for the spring itself, Basic and Metal work better.
3. No Flying Handle - if you don't want the handle to fly off and just want a grenade model, simply print either version and don't put in a spring.

Filaments used

• Outer Grenade
  • Polymaker Metallic Chrome (Amazon link)
  • Bambu Basic Light Gray
• Inner Grenade
  • Sunlu Red Silk (Amazon link)
    • Bambu Silk+ Red would work too
  • Overture Silk Gold (Amazon link)
• Top and Pin
  • Sunlu Black Silk (Amazon link)
• Spoon Handle
  • Bambu Matte Scarlet Red
  • Polymaker Metallic Chrome (Amazon link)

Metal Spring Version Assembly

1. Insert the peg into the silver/red inner part of the grenade as you see below.

2. Then slide the inner grenade into the outer grenade, push down until the peg snaps into place.

3. Insert the tiny peg/plunger into the grenade topper.  Make sure its oriented as you see below and that it sticks out the bottom.

4. Then insert the metal spring the same way you inserted the plunger/peg.

5. Lastly, screw the top onto the grenade body, doing this upside down is much easier.

Plastic Spring Version Assembly

1. Insert the peg into the silver/red inner part of the grenade as you see below.

2. Then slide the inner grenade into the outer grenade, push down until the peg snaps into place.

3. Next, insert the printed peg into the topper, make sure it sticks out the bottom, if not turn it until it does.

4. Lastly, screw the top onto the grenade body.  Its much easier to do upside down.

( ! ) Do not sell my prints — I have not authorized selling prints.  If you sell my prints on Etsy, Amazon, eBay, etc, I will find out.

This 3D print is intended for decorative purposes only and is not suitable for children. Small parts may present a choking hazard and edges may be sharp. By printing this 3D print, you assume all liability for any harm to yourself or others resulting from its use.