Kids' Star IDW Combiner Bruticus Accessory Pack

Compatibility Issues:

This model was designed with Kids' Star as a reference, normally Hasbro should also be compatible, but I cannot be certain, as I don't know the exact difference between the two

Support Issues:
For durability and appearance, the support positions are relatively difficult to remove, but it's not hard if you have the right tools, I personally recommend single-edge model nippers, buy a cheaper pair (around 30-40) because expensive ones usually have thin blades that are not durable, holding it with nippers, you can basically pull out the entire piece

Fit Issues:

Due to the precision issues of 3D printing, even products from the same manufacturer in different colors can have tolerances, so I suggest adjusting the fit using the following methods

Solution for being too tight: There's not much to say about this, it mainly involves sanding and applying lubricant, the pegs should be slowly twisted into place

Solution for being loose (Method 1): Use transparent tape to apply a layer on the contact surface, this can increase friction, and transparent tape is not too sticky (as shown in the figure below)

Solution for being loose (Method 2): Use glue, apply a small amount of glue with a toothpick, coat it around the peg, test after it dries, you can gradually build up layers until satisfied (as shown in the figure below)